q
LE display
Operation hour, voltage and frequency are indicated in turns by
means of depressing the LE display changeover switch.
In addition, "O_Lod" (overload) will be indicated when the generator
is in the overload condition or appliance(s) will be out of order.
In this case, stop the engine immediately and check the appliance
and/or generator for overloading.
After the check and remedy, restarting the engine will resume
displaying in the normal manner.
w
Operation hour lamp
Lamp (red) is turned on when changing over into operation hour indication in the LE display.
e
Voltage lamp
Lamp (red) is turned on when changing over into voltage indication in the LE display.
r
Frequency lamp
Lamp (red) is turned on when changing over into frequency indication in the LE display.
t
LE display changeover switch
When depressing this switch, indication in LE display is changed over in turns;
operation hour → voltage → frequency → operation hour.
When starting the engine, operation hour is indicated in LE display at first.
y
Auto-power saving switch
When depressing this switch, auto-power saving function is activated.
However, auto-power saving function is not activated in case of high-load condition.
u
Auto-power saving lamp
Lamp (green) is turned on while auto-power saving function is activated.
i
Engine oil level warning lamp
When the engine oil level is lower than the specified level, the lamp is turned on.
Then engine will be stopped.
8
Hours
MULTI MONITOR
V
Hz
AUTO
P-SAVE
1
457 6
2
3
q MULTI MONITOR
w AC RECEPTACLES
e GROUND TERMINAL
r DC TERMINALS
t DC CIRCUIT BREAKER
y
KEY SWITCH
u ENGINE SWITCH
i AC CIRCUIT BREAKER
MULTI MONITOR
Hours
MULTI MONITOR
V
Hz
AUTO
P-SAVE
1
8
7 6 5
32
4
■
Make sure that the appliance is switched OFF before connecting it to the generator.
■
Do not move the generator while it is running.
■
Be sure to ground the generator if the connected appliance is grounded. Failure to
ground unit may lead to electrical shock.
WARNING
2. USING ELECTRIC POWER
(1) CONTROL PANEL
NOTE:
Multi monitor is not a presised instrumentation, and so the indication on the LE display is for the reference.
P4300i au_GU2392 07.7.14 7:48 PM ページ8
Comments to this Manuals