CELECT™ Engine Position Sensor
(EPS) - Installation
Install a new EPS in the mounting hole in the block. Make
sure a new o-ring is present and in place. Use service
tool, Part No. 3822747. Tighten the EPS.
Torque Value: 34 N•m [25 ft-lb]
Lubricating Oil Pump - Installation
Install a new gasket on the mounting trunion of the lu-
bricating oil pump.
Install the lubricating oil pump in the mounting hole in the
cylinder block gear flange.
Install and tighten the five mounting capscrews.
Torque Value: 54 N•m [40 ft-lb]
Use a dial indicator to check the backlash between the
lubricating oil pump and the camshaft gear.
Install the tip of the dial indicator against a tooth on the
lubricating oil pump drive gear as shown.
Engine Assembly (00-02) CELECT™ Engine Position Sensor (EPS) - Installation
N14 Page 0-91
Comments to this Manuals