Use service tool, Part No. 3823819, to slide the two water
tubes into the adjacent water manifold.
Install the two water tube retainer clamps.
Install and tighten the retainer clamp capscrews.
Torque Value: 45 N•m [33 ft-lb]
Injectors - Installation
CELECT™ Engines
NOTE: When installing injectors for reuse, new o-rings must
be installed on the injector.
NOTE: The CELECT™ injectors require three different in-
jector o-rings. The o-rings are color coded as follows:
Top o-ring - Black
Center o-ring - Brown
Bottom o-ring - Black with a white identification dot.
Lubricate the o-rings with lubricating oil just before
installation.
Caution: Do not strike the top stop spring cage when
installing CELECT™ injectors.
Using the CELECT™ injector puller/installer, Part No.
3823579, install the injector into the cylinder head injec-
tor bore with the injector solenoid valve facing the intake
side of the engine.
After partial installation of the injector, take precautions
to center the solenoid valve between the valve springs.
Avoid contact with the spring coils. If the injector is con-
tacting a valve spring, use a screwdriver to position the
injector again.
Warning: Do not strike or pry on the solenoid. Other-
wise, injector damage will occur.
Continue driving the injector into the bore using the puller/
installer, Part No. 3283579.
Injectors - Installation Engine Assembly (00-02)
N14Page 0-100
Comments to this Manuals