If the alignment is not within specifications, remove the
housing. Check for nicks, burrs, or foreign material be-
tween the block and the housing.
Check the alignment again. If the alignment is not within
specifications, the block or the housing is not machined
correctly.
Flywheel - Installation
NOTE: Use a new pilot bearing when installing a new or
rebuilt clutch.
Use a mandrel and a hammer to remove the pilot bearing.
Use Scotch-BriteT 7448, Part No. 3823258, to clean the
pilot bore.
Use a mandrel and a hammer to install the pilot bearing.
NOTE: The pilot bearing must be installed flush with the
pilot bore surface.
Flywheel - Installation Engine Assembly (00-02)
N14Page 0-72
Comments to this Manuals