NOTE: If the cylinder block is not going to be used imme-
diately, apply a coating of preservative oil to prevent rust.
Cover the block to prevent dirt from sticking to the oil.
Camshaft Bore - Cleaning
Use a fine emery cloth to remove burrs, and clean the
bushing bores.
Camshaft Bore - Inspection
Measure the cylinder block camshaft bore inside diam-
eter.
Camshaft Bore I.D.
mm in
68.237 MIN 2.6865
68.262 MAX 2.6875
If the bore inside diameter is not within specifications, the
bore must be repaired. Refer to the Alternate Repair
Manual, Bulletin No. 3379035.
Main Bearing Bore Alignment - Measurement
NOTE: Service caps do not have the bore machined to a
final specification. If the cap is replaced, the main bearing
bore must be machined. Use the correct parts of the main
bearing boring tool, Part No. ST-1177. Refer to the Alterna-
tive Repair Manual, Bulletin No. 3379035.
Cylinder Block Cylinder Block - Cleaning and Inspection (01-02)
N14 Page 1-15
Comments to this Manuals