Turn the lubricating oil pump drive gear by hand as far as
it will freely move, and set the dial indicator to ‘‘0’’ (zero).
Turn the lubricating oil pump drive gear by hand in the
opposite direction as far as it will freely move, and read
the dial indicator.
Backlash Between the Lubricating Oil Pump Drive Gear
and the Camshaft Gear
mm in
0.05 MIN 0.002
0.50 MAX 0.020
If the backlash is not within specifications, the lubricating
oil pump drive gear must be replaced.
Gear Cover - Installation
Install one 7/16-20 X 4-inch guide stud in each side of the
gear cover mounting flange to align the cover.
Install the gear cover gasket over the guide studs and the
dowel pins.
NOTE: Use a film of LubriplateT 105 or its equivalent or
grease to hold the gear cover gasket in place, if necessary.
Install the gear cover. Install and tighten the mounting
capscrews in the sequence shown.
Torque Value: 68 N•m [50 ft-lb]
Gear Cover - Installation Engine Assembly (00-02)
N14Page 0-92
Comments to this Manuals