Lubricating Oil Pan - Removal
Remove the oil pan mounting capscrews and the oil pan.
Gear Cover - Removal
Remove one capscrew on each side of the gear cover,
and install a 7/16 - 20 X 4-inch guide stud in each location
to support the cover during removal.
Remove the remaining gear cover capscrews, and re-
move the gear cover.
Crankshaft Seal, Front - Removal
Remove the front crankshaft seal.
Accessory Drive Seal - Removal
Remove the accessory drive seal. Refer to the N14 Trou-
bleshooting and Repair Manual, Bulletin No. 3810456,
Section 7.
Camshaft - Removal
Install four camshaft pilots, Part No. 3375268, over the
outer base circle of the valve lobes between the camshaft
journals.
Use a rubber band to hold the installation pilots in place.
The rubber band must straddle the valve lobe.
Engine Disassembly (00-01) Lubricating Oil Pan - Removal
N14 Page 0-39
Comments to this Manuals