Rocker Lever - Cleaning and Inspec-
tion for Reuse (03-01)
Disassembly
Loosen the valve and injector adjusting screw lock nuts
on each rocker lever.
Turn the adjusting screws counterclockwise until the
rocker levers are loose.
Caution: Do not attempt to remove or install the rocker
lever shaft assemblies without backing out the adjusting
screws. If not loosened, damage to the dowel pins and
ring dowels can occur.
Remove the rocker lever shaft capscrews and the rocker
lever shaft assemblies.
NOTE: To prevent increased wear, mark each rocker lever
as it is removed so it can be installed back in its original
location.
Remove the rocker levers from the shaft.
Remove the lock nuts and the adjusting screws from the
rocker lever.
NOTE: To prevent increased wear, mark each adjusting
screw as it is removed so it can be installed back in its
original rocker lever.
Cleaning and Inspection
Use steam or solvent to clean the rocker lever shaft.
Dry with compressed air.
Rocker Lever - Cleaning and Inspection for Reuse (03-01) Rocker Lever Housing Assembly
N14Page 3-8
Comments to this Manuals