NOTE: When installing injectors for reuse, new o-rings must
be installed on the injector.
Lubricate the o-rings with lubricating oil just before
installation.
Install the injector and hold down clamp.
Use injector puller, Part No. 3822697, to install STC in-
jectors.
Make sure the injector oil feed is aligned over the oil
transfer tube.
Install the hold down clamp capscrew.
Torque Value: 54 N•m [40 ft-lb]
Push Tubes - Installation
Use clean 15W-40 oil to lubricate the ball end of the push
tubes.
NOTE: The injector push tubes (1) are larger in diameter
than the valve push tubes (2).
Push Tubes - Installation Engine Assembly (00-02)
N14Page 0-102
Comments to this Manuals