Immediately after cleaning and inspecting, apply a film of
clean engine lubricating oil to capscrews that are to be
used again.
Cylinder Head - Replacing the Valve
Guides (02-03)
Disassembly
Use a valve guide driver, Part No. 3376398, (1) and an
arbor press to remove the old valve guides (2).
Cleaning
Use a flexible brush and solvent to clean the valve guide
bores in the cylinder head. Dry with compressed air.
Inspection
Measure the inside diameter of the valve guide bore in the
cylinder head.
Valve Guide Bore I.D.
mm in
19.05 MIN 0.750
19.07 MAX 0.751
NOTE: If the valve guide bore is worn larger than the max-
imum specified, the valve guide bore can be machined and
0.25 mm [0.010-inch] or 0.38 mm [0.015-inch] oversize valve
guides installed. Refer to the Alternative Repair Manual,
Bulletin No. 3379035.
Cylinder Head Cylinder Head - Replacing the Valve Guides (02-03)
N14 Page 2-25
Comments to this Manuals